Antenna; Monitor - Ten-Tec OMNI-VII 588 Programmer's Reference Manual

Antenna

The OMNI-VII has connections for two HF Transceiver Antennas, and one HF
Receiver Antenna. These are referred to as ANT1, ANT2, and RXAUX on the radio
selection menus.
Format:
Where:
Example1:
Example2:

Monitor

The relative Monitor can be controlled over a range of 0-127. A setting of 0
represents Monitor Off, whereas a setting of 127 (0x7f) represents the maximum Monitor
setting of 100%.
Format:
Where:
Example:
Rev 1.009
OMNI-VII Firmware Updates at www.rfsquared.com
'*' 'C1V <d0> <CR>
'*' = the ASCII '*' symbol (0x2a)
C1V= the ASCII 'C1V characters (<0x43><0x31><0x56>)
<d0> = binary 0 = RX=TX=ANT1
= binary 1 = RX=TX=ANT2
= binary 2 = RX=RXAUX, TX=ANT1
= binary 3 = RX=RXAUX, TX=ANT2
*C1V0<CR> sets Receive and Transmit to ANT1
*C1V2<CR> sets Receive to RXAUX and Transmit to ANT1
'*' 'C1W' <d0> <CR>
'*' = the ASCII '*' symbol (0x2a)
C1W = the ASCII 'C1W' characters (<0x43><0x31><0x57>)
<d0> = 7 bit Monitor selection (0x00 to 0x7f)
*C1W<0x3f><CR> sets Monitor to decimal 63 (50%)
OMNI-VII Programmer's Reference Guide 41 of 63