Split State - Extended Format; Vox Trip Level - Ten-Tec OMNI-VII 588 Programmer's Reference Manual

Split State – Extended Format
Split State Selection in REMOTE MODE is available in the same command format
as in RADIO MODE using the *N ?N command query. Split State is also adjustable in
the extended command set as follows: (This extended command gives no additional
functionality over the N command. Only supported because existing programs use the
extended format, and the radio command was added to support other programs)
Format:
Where:
Example:

VOX TRIP Level

The relative VOX Trip Level can be controlled over a range of 0-127. A setting of 0
represents lowest Trip setting, and 127 (0x7f) represents maximum Trip level.
Format:
Where:
Example:
Rev 1.009
OMNI-VII Firmware Updates at www.rfsquared.com
'*' 'C2B' <d0> <CR>
'*' = the ASCII '*' symbol (0x2a)
C2B = the ASCII 'C2B' characters (<0x43><0x32><0x42>)
<d0> = 0 = SPLIT OFF
= 1 = SPLIT ON
*C2B<0x00><CR> turns off SPLIT state
'*' 'C2C' <d0> <CR>
'*' = the ASCII '*' symbol (0x2a)
C2C = the ASCII 'C2C' characters (<0x43><0x32><0x43>)
<d0> = 7 bit VOX Trip selection (0x00 to 0x7f)
*C2C<0x3f><CR> sets VOX Trip to decimal 63 (50%)
OMNI-VII Programmer's Reference Guide 44 of 63