Sidetone Frequency; Cw Qsk Delay - Ten-Tec OMNI-VII 588 Programmer's Reference Manual

Sidetone Frequency

The Sidetone Frequency can be set to 0-1270Hz in 10 Hz steps.
Format:
Where:
Example1:
Example2:

CW QSK Delay

The CW QSK Delay adjusts the amount of time it takes for receive audio to be
restored after finishing transmission of a CW dit/dah. The range is from 0, for full break
in, up to 127 for maximum delay of about 1 second time. This control does not hold off
the next transmit. Only sets the time that the next receive will be enabled providing that
another transmit doesn't start during that timeframe.
Format:
Where:
Example1:
Example2:
Rev 1.009
OMNI-VII Firmware Updates at www.rfsquared.com
'*' 'C1L' <d0> <CR>
'*' = the ASCII '*' symbol (0x2a)
C1L = the ASCII 'C1L' characters (<0x43><0x31><0x4C>)
<d0> = 7 bit Sidetone Frequency Selection (0x00 to 0x7f)
*C1L<0x64><CR> sets Sidetone Frequency to 1000 Hz
*C1L<0x28><CR> sets Sidetone Frequency to 400 Hz
'*' 'C1M' <d0> <CR>
'*' = the ASCII '*' symbol (0x2a)
C1M = the ASCII 'C1M' characters (<0x43><0x31><0x4D>)
<d0> = 7 bit CW QSK Delay Selection (0x00 to 0x7f)
*C1M<0x7f><CR> sets CW QSK Delay to 100% (1 second)
*C1M<0x00><CR> sets CW QSK Delay to 0% (full break-in)
OMNI-VII Programmer's Reference Guide 35 of 63