Manual Notch On/Off; Manual Notch Center Frequency - Ten-Tec OMNI-VII 588 Programmer's Reference Manual

Manual NOTCH On/Off

This controls whether the OMNI-VII Manual Notch is engaged or not.
Format:
Where:
Example:

Manual NOTCH Center Frequency

The relative Manual NOTCH Center Frequency can be controlled over a range of 0-
127. A setting of 0 represents lowest Manual NOTCH Center Frequency of 20 Hz, and
127 (0x7f) represents maximum Manual NOTCH Center Frequency of 4000Hz.
The formula is 40 * MANNCHCF_Selected + 20 Hz
Format:
Where:
Example:
Rev 1.009
OMNI-VII Firmware Updates at www.rfsquared.com
'*' 'C2H' <d0> <CR>
'*' = the ASCII '*' symbol (0x2a)
C2H = the ASCII 'C2H' characters (<0x43><0x32><0x48>)
<d0> = binary 0 = Manual Notch OFF
= binary 1 = Manual Notch ON
*C2H<0x01><CR> Turns ON Manual Notch
'*' 'C2I' <d0> <CR>
'*' = the ASCII '*' symbol (0x2a)
C2I = the ASCII 'C2I' characters (<0x43><0x32><0x49>)
<d0> = 7 bit MANNCHCF_Selected selection (0x00 to 0x7f)
*C2I<0x00><CR> sets Manual Notch Center Frequency to 20Hz
OMNI-VII Programmer's Reference Guide 47 of 63