Preamp On/Off; Remote Tune - Ten-Tec OMNI-VII 588 Programmer's Reference Manual

PREAmp On/Off

This controls whether the OMNI-VII will engage the Pre-Amplifier or not. The range
is from 0 for Pre-Amplifier OFF, to 1 for Pre-Amplifier ON.
Format:
Where:
Example:

Remote Tune

The OMNI-VII can be told to enter the TUNING state or exit the TUNING state by
sending this command. There are no parameters for this command. Once initiated, the
OMNI-VII performs exactly the same functions as if you had pushed the TUNE button
locally. It is best for your application to send this command, and then read the
corresponding query until the status shows that the TUNE cycle is complete.
Format:
Where:
Example:
Example:
Query Format:
Radio Returns:
Where:
Rev 1.009
OMNI-VII Firmware Updates at www.rfsquared.com
'*' 'C1Z' <d0> <CR>
'*' = the ASCII '*' symbol (0x2a)
C1Z = the ASCII 'C1Z' characters (<0x43><0x31><0x5A>)
<d0> = binary 0 for PreAmp Off
= binary 1 for PreAMp On
*C1Z<0x01><CR> Turns the Pre-Amplifier ON.
'*' 'C2A' <CR>
'*' = the ASCII '*' symbol (0x2a)
C2A = the ASCII 'C2A' characters (<0x43><0x32><0x41>)
*C2A<CR> Tells the OMNI-VII to start its tuning cycle
*C2A<CR> Tells the OMNI-VII to start its tuning cycle
*C2A <CR> if the OMNI-VII is manually tuning, then this
command will tell it to stop tuning.
?C2A<CR>
C2A <d0> <CR>
<d0> = bit 0 = 0 => Auto Tuner Not Enabled
= 1 => Auto Tuner Enabled
= bit 1 = 0 => Not Currently Tuning
= 1 => Currently Tuning
= bit 2 = 0 => Not Tuned / = Bypassed
= 1 => Tuned
OMNI-VII Programmer's Reference Guide 43 of 63