Pod Passthru Notification - Ten-Tec OMNI-VII 588 Programmer's Reference Manual

POD PASSTHRU Notification

The format of the POD PASSTHRU Notification from the OMNI-VII to the
computer via the serial port that a POD key has been pressed/released is as follows:
Format:
Where:
Example1:
Example2:
Remote Key Key Press
Label Code
F1
F2
F3
"." (Period)
E
0
1
2
Rev 1.009
OMNI-VII Firmware Updates at www.rfsquared.com
'Q' <d0> <CR>
Q = the ASCII 'Q' character (0x51)
<d0> = key press code...
See Diagram Below.
If b7 of d0 is low, then the key was depressed.
If b7 of d0 is high, then the key was released.
Q<0x38><CR> means that the "8" key is depressed.
Q<0xb8><CR> means that the "8" key is released.
Remote Key
Label
0x11 3
0x12 4
0x13 5
0x2e 6
0x0d 7
0x30 8
0x31 9
0x32
OMNI-VII Programmer's Reference Guide
Key Press
Code
0x33
0x34
0x35
0x36
0x37
0x38
0x39
52 of 63