Auto Tuner; Sidetone Volume - Ten-Tec OMNI-VII 588 Programmer's Reference Manual

Auto Tuner

This controls whether the OMNI-VII will control the optional Auto Tuner or not. It
is possible to have an Auto Tuner installed, yet you may want to force it to not use the
Auto Tuner under certain conditions. The range is from 0 for Auto Tuner Not Installed, to
1 for Auto Tuner Installed. Not Installed forces the OMNI-VII to send the Auto Tuner
Bypass control to the Auto Tuner, making sure that it is bypassed.
Format:
Where:
Example:

Sidetone Volume

The relative Sidetone Volume can be controlled over a range of 0-127. A setting of 0
represents Sidetone Off, whereas a setting of 127 (0x7f) represents the maximum
Sidetone Volume setting of 100%.
Format:
Where:
Example:
Rev 1.009
OMNI-VII Firmware Updates at www.rfsquared.com
'*' 'C1P' <d0> <CR>
'*' = the ASCII '*' symbol (0x2a)
C1P = the ASCII 'C1P' characters (<0x43><0x31><0x50>)
<d0> = binary 0 for Auto Tuner Not Installed
= binary 1 for Auto Tuner Installed
*C1P<0x00><CR> Disables using the Auto Tuner.
'*' 'C1Q' <d0> <CR>
'*' = the ASCII '*' symbol (0x2a)
C1Q = the ASCII 'C1Q' characters (<0x43><0x31><0x51>)
<d0> = 7 bit sidetone volume selection (0x00 to 0x7f)
*C1Q<0x3f><CR> sets Sidetone Volume to decimal 63 (50%)
OMNI-VII Programmer's Reference Guide 38 of 63