Parallel Function Setting; Parallel Cable Connection - PROLiNK Master III Series User Manual

9-2.3 Install Power Module of Cabinet C & D
1. Please follow table2-1，if there are more than 2 cabinet in parallel
2. Refer to Table 9-1 to set the Cabinet.
9.2.4 Parallel Board information
The parallel board is on the back of the cabinet. Please follow table 9-1 to set the parallel units.

9-3 Parallel Function Setting

1. For the input and output wiring, please be sure to follow section 9.1 Input and Output Wiring to prepare.
2. For the Module Address Setting and Cabinet setting, please be sure to follow section 9.2.
3. Please confirm that the ID setting of the module and the cabinet must be matched correctly, so
as not to affect the normal operation of parallel connection. Please follow table2-1

9-4 Parallel Cable Connection

Parallel cable is equipped with 20-pins connectors. Insert the 20-pins connector into the parallel board shown in
figure 9-2. Both cabinets use the same way to connect the parallel cable.
DIP SW 1 Terminal resistance
DIP SW 2 Parallel set pin
DIP SW 3 Parallel set pin
DIP SW 4 NC
Cabinet A SW2 ON
Cabinet B SW2 OFF SW3 ON
Cabinet C SW2 ON
Cabinet D SW2 OFF SW3 OFF
Table 9-1
Figure 9-2
73
SW3 ON
SW3 OFF