Table of Contents
Advertisement
Secure Protocol
Encrypt the communication between your PC and the machine using the SSL encryption. After changing the
setting, restart the system or turn the machine OFF and then ON again. For detailed information on restarting
the system, refer to Restarting the System on page 8-63.
The following Secure Protocol settings are available.
•
SSL Setup ...8-69
•
IPP Security Setup ...8-69
•
HTTP Security Setup ...8-69
•
LDAP Security Setup ...8-70
SSL Setup
Select whether or not to use SSL. The default setting is On. Use the procedure below.
1
Press the System Menu key.
2
Press [System], [Next] of Network, [Next] of Secure Protocol, and then [Next] of SSL.
3
Press [On] or [Off].
4
Press [OK].
5
After changing the setting, restart the system or turn the machine OFF and then ON again.
For detailed information on restarting the system, refer to Restarting the System on page 8-63.
IPP Security Setup
Select the IPP security level. This setup is available when SSL is On. The default setting is IPP over SSL Only.
NOTE:
IPP must be set to [On] in Protocol Detail on page 8-66.
Use the procedure below.
1
Press the System Menu key.
2
Press [System], [Next] of Network, [Next] of Secure Protocol, and then [Change] of IPP Security.
3
Press [IPP over SSL Only] or [IPP or IPP over SSL].
4
Press [OK].
5
After changing the setting, restart the system or turn the machine OFF and then ON again.
For detailed information on restarting the system, refer to Restarting the System on page 8-63.
HTTP Security Setup
Select the HTTP security level. This setup is available when SSL is On. The default setting is HTTPS Only.
8-69
Default Setting (System Menu)
8
Advertisement
Table of Contents
