Olivetti d-Copia 3001MF Operation Manual page 138

Border Erase to Back Page
When scanning a 2-sided original, this allows you to erase the borders on the back of the original. The table
below shows the available settings.
Same as Front
Page
Do Not Erase
NOTE:
You can change the default setting for Border Erase to Back Page. For details, refer to Paper
Selection on page 8-25.
Use the procedure below to erase borders when copying.
Ready to copy.
Border Erase
Off
Border Erase
Place original.
Sheet
Border Erase
Book
Individual
Original :
---
Border Erase
Zoom : 100%
Paper :
---
Preview
Add Shortcut
Status
Ready to copy.
Border Erase
Off
Border Erase
Place original.
Sheet
Border Erase
Book
Individual
Original : ---
Border Erase
:
Zoom 100%
Paper : ---
Preview
Add Shortcut
Status
Item
Border Erase performed using the same setting
as the front page
No Border Erase performed on the back page
Copies
Border (0 - 50)
6
mm
Same as
# Keys
Front Page
Back Page
Gutter (0 - 50)
6
mm
# Keys
Cancel OK
08/08/2009
Copies
(0 - 50)
Top 6
mm
Bottom 6
mm
Same as
Front Page
6
Left
mm
Back Page
Right 6
mm
Top Edge Top
Original
Orientation
# Keys
Cancel OK
08/08/2009
Detail
1
Press the Copy key.
2
Place the originals on the platen.
3
Press [Layout/Edit] and then [Border Erase].
4
Select [Border Erase Sheet] to erase borders for an
individual sheet or [Border Erase Book] to erase
borders for a book.
Use [+] or [–] to enter the width in Border or Gutter.
Press [# Keys] to use the numeric keys for entry.
10:10
Press [Individual Border Erase] to select the
individual border erase.
Use [+] or [–] to enter the width in Top, Bottom, Left
or Right. Press [# Keys] to use the numeric keys for
entry.
Press [Original Orientation] to select the original
orientation from either [Top Edge Top] or [Top Edge
Left]. Then press [OK].
For 2-sided originals, press [Back Page] and then
10:10
press [Same as Front Page] or [Do Not Erase].
5
Press [OK].
6
Press the Start key to start copying.
4-18
Copying Functions