Table of Contents
Advertisement
Use the procedure below to specify the setting for correcting fine black lines.
1
Press the System Menu key.
2
Press [
], [Adjustment/Maintenance] and then [Change] of Correcting Black Line.
3
Press [Off], [On(Low)] or [On(High)].
4
Press [OK].
System Initialization
Initialize the hard disk mounted on the machine to return to the default mode.
Refer to System Initialization on page 8-63 about the initialization procedures.
Display Brightness
Set the brightness of the touch panel.
Use the procedure below to adjust the display brightness.
1
Press the System Menu key.
2
Press [
], [Adjustment/Maintenance] and then [Change] of Display Brightness.
3
Press [1] - [4] (Darker- Lighter) to adjust brightness.
4
Press [OK].
Silent Mode
Make the machine run more quietly. Select this mode when the running noise is uncomfortable.
Use the procedure below to set Silent mode.
1
Press the System Menu key.
2
Press [
], [Adjustment/Maintenance] and then [Change] of Silent Mode.
3
Press [Off] or [On].
4
Press [OK].
Auto Color Correction
This setting allows you to adjust the detection level used by the machine to determine whether the original is
color or black and white during Auto Color Mode. Setting a lower value will result in more originals being
identified as color, while a larger value will tend to increase the number of originals being identified as black and
white.
Use the procedure below to set the Auto Color Detection Level.
1
Press the System Menu key.
2
Press [
], [Adjustment/Maintenance], [
3
Press one of keys [1] to [5] (Color - B & W) to set the detection level.
4
Press [OK].
] and then [Change] of Auto Color Correction.
8-44
Default Setting (System Menu)
Advertisement
Table of Contents
