Border Erase To - Olivetti d-Copia 3001MF Operation Manual

Border Erase to Back Page
When scanning a 2-sided original, this allows you to erase the borders on the back of the original. The table
below shows the available settings.
Same as Front
Page
Do Not Erase
Use the procedure below to erase borders when sending scanned originals.
Ready to send.
Place original.
Border Erase
Off
Border Erase
Place original.
Sheet
Border Erase
Book
Individual
Original : ---
Border Erase
Zoom : 100%
Send : ---
Preview
Add Shortcut
Status
Ready to send.
Place original.
Border Erase
Off
Border Erase
Place original.
Sheet
Border Erase
Book
Individual
Original : ---
Border Erase
Zoom : 100%
Send : ---
Preview
Add Shortcut
Status
Item
Border Erase performed using the same setting as the
front page
No Border Erase performed on the back page
Destination
(0 - 50)
Border
6
mm
Same as
# Keys
Front Page
Back Page
(0 - 50)
Gutter
6
mm
# Keys
Cancel OK
08/08/2009
Destination
(0 - 50)
Top
6
mm
6
Bottom
mm
Same as
Front Page
6
Left
mm
Back Page
6
Right
mm
Top Edge Top
Original
Orientation
# Keys
Cancel OK
08/08/2009
Detail
1
Press the Send key.
2
Place the originals on the platen.
3
Press [Advanced Setup] and then [Border Erase].
4
Press [Border Erase Sheet] to erase borders for an
individual sheet or [Border Erase Book] to erase
borders for a book.
Use [+] or [-] to enter the width in Border or Gutter.
Press [# Keys] to use the number keys for entry.
Press [Individual Border Erase] to select the
individual border erase.
Use [+] or [-] to enter the border width or press [#
Keys] and enter the width using the numeric keys.
10:10
Press [Original Orientation] to select the original
orientation from either [Top Edge Top] or [Top Edge
Left], and press [OK].
For 2-sided originals, press [Back Page] and then
press [Same as Front Page] or [Do Not Erase].
5
Press [OK].
10:10
6
Specify the destination, and press the Start key to
start sending.
5-24
Sending Functions