Features - ETAS BR-XETK-S1.0 User Manual

15 | Introduction
2.2

Features

- Measurement interface:
• 3.3 V DAP output levels, 5.0 V tolerant DAP input
• Configurable DAP interface clock speed: 50 MHz, 100 MHz
• Pinless startup protocol for XETK recognition and data acquisition trig-
- Calibration:
• Microcontroller capability of internal Flash emulation can be used
• XETK powers Emulation Device RAM (for calibration purpose)
• Supports "Start on Any Page"
- Supports special coldstart mechanism ("Calibration Wake Up"):
• Calibration Wake Up: Wake up mechanism to wake up the power supply
• Pull CalWakeUp until Startup Handshake: duration of the Wake up mech-
- ECU flashing via XETK
• Braindead flashing under ProF control
- Permanent storage of configuration in EEPROM
- Automotive Ethernet Interface:
• Connection to PC via Automotive Ethernet to Standard Ethernet Media
• Open XCP on Ethernet Protocol
• Supports a variety of standard applications
- "ETK Drivers and Tools" update to support ETAS software tools (INCA, XCT)
- Firmware update (programming of the logic device) through HSP software
service packs; removal of XETK or ECU is not necessary
- Mounting possibilities inside or on top of ECU
- Temperature range suitable for automotive application
For more technical data on the BR_XETK-S1.0 consult the chapter "Technical Data"
on page 36.
ETAS BR_XETK-S1.0 | User Guide
gering
of the ECU via the Calibration Wake up pin
anism is configurable
Converter