Introduction; Applications - ETAS BR-XETK-S1.0 User Manual

14 | Introduction

2 Introduction
This chapter contains information about the following topics:

• Applications. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14

• Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15
2.1 Applications
The BR_XETK-S1.0 is an emulator probe for the Infineon AURIX microcontroller
family. It is a serial XETK with an Automotive Ethernet (100BASE-T1) interface.
NOTE
For supported Infineon AURIX microcontrollers, refer to chapter 6.1.3 on page 37.
Fig. 2-1
An Automotive Ethernet media converter is required for the access to the BR_X-
ETK-S1.0 by the standard full duplex 100Base-T Ethernet of the PC.
To connect the PC with the BR_XETK-S1.0 and the Automotive Ethernet interface,
ETAS offers different modules:
- CBEB100.1, CBEB105.1, ES160.1, ES162.1, and ES165.1 Automotive Ethernet
Media Converter
- ES882.1 and ES886.1 ECU Interface Module
The BR_XETK-S1.0 can be used for Rapid Prototyping applications (bypass) as well
as for measurement and calibration applications.
ECU interface connector
Power supply connector
Power supply for ED devices (VDDS-
BRAM)
SBRAM sense
Pinless triggering
Timer triggering
ETAS BR_XETK-S1.0 | User Guide
BR_XETK-S1.0
BR_XETK-S1.0
10 pin SAMTEC
6 pin MOLEX
Min. 1.25 V
Yes, on board or external sense
Yes
Yes