Table of Contents
Advertisement
Installation in a new fireplace
8.11
NTC room temperature sensor (Opti-Air system only)
1.
2.
8.12
Battery holder (Opti-Air system only)
1.
2.
8.13
Final check on the appliance
1.
2.
3.
4.
40
Put the point of the NTC room
temperature sensor (this is the thin
black cable) in the ventilation air inlet
opening. Make sure to put the sensor
point in the path of the ventilation air
opening.
Make sure there is no tension on the
sensor cable.
Put a 9V block battery in the battery
holder and close the holder.
Make sure the battery holder is
accessible through the inlet opening
of the ventilation air.
Caution:
Wait 4 weeks after the installation before you use the appliance. The cement
used for the fireplace needs to harden and to avoid damage to the plaster
work.
Make sure the door closes and opens easy.
If applicable, make sure the control lever moves easy to left and right without undue
noise.
Make sure all cast iron plates and the baffles are in the correct position.
Contact your dealer if the final check shows a defect.
Cuatro-7 75-60
Advertisement
Table of Contents
