Table of Contents
Advertisement
7
Installation in an existing open fireplace
7.1
Install the appliance - general procedure
1.
2.
3.
4.
7.2
Preparation
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. Carefully remove the flue pipe connector. Make sure the gasket on the flue pipe
7.3
Install the appliance
1.
2.
3.
4.
5.
6.
Cuatro-7 75-60
Prepare the appliance. Refer to section 7.2.
Install the appliance. Refer to section 7.3.
Horizontally align the appliance. Refer to section 7.4.
Do a final check. Refer to section 7.5.
Remove all items from the floor of the open fireplace.
Make sure the floor of the open fireplace is flat and not damaged.
Make sure the inner walls of the open fireplace are not damaged.
Put a layer of ceramic wool on the 2 sides, rear and top of the appliance. Refer to
section
5.1
for specifications.
Put an appropriate chimney adapter on the existing chimney. Make sure there is no
gap between the chimney adapter and the existing chimney.
Connect a stainless steel flexible pipe of sufficient length to the chimney adapter and
secure it with a hose clamp.
Put a layer of ceramic wool around the flexible flue pipe.
Remove the interior of the appliance. Refer to section
Remove the screws that hold the flue
pipe connector
connector does not damage. Replace a damaged gasket.
Connect the stainless steel flexible flue pipe to the chimney adapter. Use a hose
clamp to attach the flexible flue pipe to the chimney adapter.
Put the appliance in the correct position in the existing fireplace .
Make sure that the appliance is installed horizontally. Use a spirit level.
Pull the flexible flue pipe through the opening in the top of the appliance
Connect the flexible flue pipe on the flue pipe connector. Use a hose clamp. Make
sure the gasket on the flue pipe connector is not damaged.
Push the flue pipe connector with the flue pipe into the correct position in the
appliance.
Installation in an existing open fireplace
10.5
for instructions.
29
Advertisement
Table of Contents
