Measure For Taking Out Of Operation - Thermo Scientific HM340E Operation Manual

Measure for taking out of Operation

•
Turn off the power switch of the instrument.
•
Activate the mechanical hand wheel brake.
•
Remove knife or blade and store it in a safe place.
•
Remove the section waste tray.
For Transporting Outside Closed Buildings, please Observe the Following Measures
•
Turn off the mains switch of the instrument.
•
Activate the mechanical hand wheel brake.
•
Remove knife or blade and store it in a safe place.
•
Remove the section waste tray, the operating panel, the knife/blade carrier and the specimen clamp.
These parts have to be packed separatly.
•
To lift the instrument, use the recessed grip on the lower front and rear side of the instrument.
During transport, do not move the instrument by holding the hand wheel handle. Danger of injury!
Use the original packing material since it protects the instrument optimally during transport.
Shipping of the instrument requires original packaging materials! Damages caused by shipping in
non original packaging is not covered by the manufacturer warranty! Any damage repairs resulting
from shipping in other material is charged to the shipping party. We reserve the right NOT to
repair the instrument if it is too badly damaged.
To order original packaging materials if needed, please contact Thermo Fisher Scientific International or your
local, authorised Thermo Fisher Scientific dealer.
The user must insure clean and safe conditions of the instrument when returning it to an appropriate
service provider.
Note
In case the instrument or parts of the instruments is/are sent to Thermo Fisher Scientific or to one of its
representatives in a condition which has potential danger of infection, the instrument and/or the part(s) will be
returned to the customer in an unrepaired status. Costs for this are to be charged to the customer.
58
Thermo Scientific Rotary Microtome HM 340E