Knife and Blade Carriers
Due to moving parts on the knife/blade holder and the extrem sharp- ness of the microtome knife
or blade, a danger area arises, which might lead to hand injuries if the safety features and the
instruction manual are not followed carefully. The knife or blade carriers are equipped with a knife
guard for user safety while adjusting knife or blade and specimen.
Always cover the knife/blade edge with the knife guard when adjusting specimen and/or the
blade/knife.
Disposable Blade Carrier ER
The disposable blade carrier ER is designed to take all commercially available high and low profile blades.
Using Low Profile Blades
•
Insert the blade into the slot behind the clamping plate [e] by tur- ning the clamping lever [g] towards
the front. Swing the knife guard [d] to the front.
•
Loosen the clamping lever [g] and, if necessary, slightly push the lower part of the clamping plate [e] as
well.
•
Insert the blade on the rail [c] and push it from the side to the middle.
•
Afterwards, return the clamping lever [g] upright, thus locking the blade in position.
•
After loosening the clamping lever [b] and after having moved
•
the knife guard [d] upwards, move the blade together with the entire upper part without having to
loosen the blade clamping.
•
This way, the entire cutting length of the blade can be used.
•
Then tighten the clamping lever [b].
The lever [b] can be removed by pulling it off towards the side.
Thermo Scientific Rotary Microtome HM 340E
41