Table of Contents
Advertisement
Available languages
Available languages
INSTALLING LEVELING LEGS
INSTALLING LEVELING LEGS
1. Prepare dryer for leveling legs (Feet have already been
installed on this unit).
NOTE: Slide dryer onto cardboard or hardboard before moving to
avoid damaging floor covering.
Using two or more people, move dryer to desired installation
location.
Take tape off front corners of dryer. Open dryer and remove
the literature and parts packages. Wipe drum interior with damp
cloth to remove any dust.
Take two cardboard corners from the dryer carton and place them
on the floor in back of the dryer. Firmly grasp body of the dryer and
gently lay it on its back on the cardboard corners.
16
2. Screw in leveling legs
Examine leveling legs and find diamond
marking. Screw legs into leg holes by
hand. Use an adjustable wrench or
25 mm (1") hex-head socket wrench to finish
turning legs until diamond marking
is no longer visible. Then fit a covered foot boot
over each leg foot.
To protect the floor, use a large piece of cardboard from the dryer
carton. Stand dryer up on the cardboard. Slide the dryer until
it is close to its final location. Leave enough room for electrical
connection and to connect the exhaust vent.
Diamond
Diamond
marking
Marking
Foot
Foot
Advertisement
Table of Contents
