Install Sil3114 Sata Driver On Windows 98Se/Me - SOLTEK 865Pro-FGR Manual

3-7 Install SIL3114 SATA Driver on Windows 98SE/ME

For Windows 98SE/ME users of SATA interface supported by Silicon
Image Sil3114 SATA RAID Controller, please pay attention to the fol-
lowing extraordinary configuration in BIOS Setup:
When Windows 98SE/ME system is to be installed on SATA interface,
the configuration of "Sil3114 Configuration" in "Advanced BIOS Fea-
tures" of BIOS should be set to "IDE Mode".
(1) Get ready the Support CD holding the SATA Driver.
(2) Check that SATA Hard Disks are connected properly to the SATA
connectors.
(3) Start your system and format the hard disks.
(4) Now, apply the Windows 98SE/ME CD to CD-ROM for operating
system installation.
(5) Start Windows 98SE/ME.
(6) On the "Start" screen of your system, please click to the following
path:
\My Computer\properties\Device manager
(7) In the "Device manager" screen, you can see the item " PCI RAID
Controller" with a yellow question mark on its left side, which indicates
that the RAID controller is already detected by system but the driver
is not installed yet. Please point to this item with your mouse and
double click on it (or click the "Properties" button).
The question mark here indicates
that SATA Controller Driver
is not installed yet.
Chapter 3 Software Setup
55