SOLTEK 865Pro-FGR Manual page 105

865Pro-FGR
5-7-2 Sil3114 SATA RAID Driver on Windows 98SE/Me
For Windows 98SE/Me users of SATA RAID interface supported by Sili-
con Image SIL3114 SATA RAID Controller, please pay attention to the
following extraordinary configuration in BIOS Setup:
When Windows 98SE/Me system is to be installed on SATA RAID
interface, the configuration of "Sil3114 Configuration" in "Advanced BIOS
Features" of BIOS should be set to "RAID Mode".
(1) Get ready the Floppy Diskette holding the SATA/RAID Driver.
(2) Check that SATA Hard Disks are connected properly to the SATA
Connectors.
(3) Start your system and use RAID BIOS Setup Utility to configure
RAID 0 or RAID 1 or RAID 0+1 to the hard disks. (For SATA Interface,
skip the RAID configuration.)
(4) Restart System and format the bootable hard disks.
(5) Now, apply the Windows 98SE/Me CD to CD-ROM for operating
system installation.
(6) Start the Windows 98SE/Me system.
(7) On the "Start" screen of your system, please click to the following
path:
\My Computer\properties\Device manager
(8) In the "Device manager" screen, you can see the item " PCI RAID
Controller" with a yellow question mark on its left side, which indi-
cates that the RAID controller is already detected by system but the
driver is not installed yet. Please point to this item with your mouse
and double click on it (or click the "Properties" button).
The question mark here indicates
that RAID Controller Driver
is not installed yet.
108