To Install Raid Driver On Windows 98Se/Me - SOLTEK SL-B8D-F Manual

SL-B8D-F/SL-B8D-FR

5-12-2 To Install RAID Driver on Windows 98SE/Me

(1) Get ready the Floppy Diskette holding the RAID Driver.
(2) Check that Hard Disks are connected properly to the RAID conn-
ectors.
(3) Start your system and use RAID BIOS Setup Utility to configure
RAID 0 / 1/ 0+1 to the hard disks.
(4) Restart System and format the bootable hard disks.
(5) Now, apply the Windows 98SE/ME CD to CD-ROM for
operating system installation.
(6) With the Windows 98SE/ME installation complete, restart system
for RAID driver setup.
(7) On the "Start" screen of your system, please click to the following
path:
\My Computer\properties\Device manager
(8) In the "Device manager" screen, you can see the item " PCI RAID
Controller" with a yellow question mark on its left side, which indicates
that the RAID controller is already detected by system but the driver
is not installed yet. Please point to this item with your mouse and
double click on it (or click the "Properties" button).
The question mark here
indicates that RAID
Controller Driver
is not installed yet.
(9) Instantly, the "PCI RAID Controller Properties" screen shows up.
Please click the "General" bar to continue.
(10) In the "General" screen, click "reinstall
Driver" button to continue. Please note that
the status of "Device Usage" should stay at
"Exists in all hardware profiles".
92