SOLTEK 865Pro-FGR Manual page 67

865Pro-FGR
LBA/Large mode
Block (Multi-Sector
Transfer)
PIO Mode
DMA Mode
S.M.A.R.T
32Bit Data Transfer
4-6.3.2-3 Hard Disk Write Protect
Hard Disk Write
Protect
4-6.3.2-4 IDE Detect Time Out
IDE Detect Time Out
4-6.3.2-5 ATA(P) 80Pin Cable Detection
ATA(PI) 80Pin Cable
Detection
Type To select the types of the IDE devices:
Not Installed; Auto: Setting type automatically
CD-ROM: ATAPI (Packet Interface) CD-ROM drive
ARMD: ATAPI Removable Media Device
To auto-select (default) or disable LBA/Large mode.
To auto-select (default) or disable Block Mode. If
disabled, the data transfer from and to the device
occurs one sector at a time; if enabled, the data
transfer from and to the device occurs multiple
sectors at a time.
To auto-select (default) or disable PIO Mode.
Choices: Disabled; 1, 2, 3, 4
To auto-select (default) or disable DMA Mode.
Choices: Auto; SWDMA(0-2); MWDMA(0-2);
UDMA(0-4)
Allows you to enable / disable the Self Monitoring
Analysis and Reporting Technology for the hard disk.
Choices: Auto(default); Enabled; Disabled
To auto-select (default) or disable 32Bit Data
Transfer.
Allows you to Enabled / Disable(default) Hard Disk
Write Protection
Allows you to set time out for IDE Detection.
(Sec) Choices: 0 - 35 seconds in 5 seconds stepping
Allows you to select ATA(PI) devices for 80Pin Cable
Detection. To set Host & Device allows onboard IDE
controller and IDE disk drive to detect the type of
IDE cable used.
Choices: Host & Device, Host, Device
70