Holding cursor over value displays Tool Tips
Figure 1.4.7: Illegal Parameters/Tool Tips
R e t u r n i n g t o F a c t o r y D e f a u l t s
To return to the Factory Defaults, click the "Default" button and the "Set"
button. The Factory Defaults will be restored.
Parameters will return to Default
Click "Defaults"...
Figure 1.4.8: Returning to Factory Defaults
If a fault occurs it will be displayed in the Fault window. If more than one
fault occurs each one will be displayed with the + (plus sign) between them.
The Table below lists the faults and the characters displayed for each.
Binary Code*
0
4
8
16
32
*NOTE: All fault codes are "OR"ed together.
Fault Table
Display
None
CS
SPI Write to Settings Check Sum
CS
SPI Write to Defaults Check Sum
DFLT
DATA
EEPROM Check Sum Fault
Table 1.4.1: Fault Indication
...then click "Set"
Fault Condition
No Fault
Defaults Check Sum
31