Startup; The Ims Motor Interface Gui Configuration Utility; Figure 1.4.4 Typical Mdmf, Mdmp Gui - IMS MDRIVE 17 Operating Instructions Manual

S t a r t u p
Select "Start>Programs>IMS SPI Interface>IMS SPI Interface". The
configuration utility will automatically scan your LPT ports for the connected
MDrive and configure the communications. The connection status and port
are displayed at the bottom of the configuration screen. The Version Number
of the Firmware in your MDrive will also be displayed at the top of the
configuration utility as shown below.
T h e I M S M o t o r I n t e r f a c e G U I C o n f i g u r a t i o n U t i l i t y
The IMS Motor Interface GUI (Graphical User Interface) simplifies use with
a single screen interface for configuring the MDrive17 and MDrive23. All of
the parameters and commands are controlled from this single screen.
There are three versions of MDrive.
MDMF - MDrive Microstepping with Flying Leads
MDMP - MDrive Microstepping with a Pluggable Connector
MDMC - MDrive Microstepping with "C" Connector
G U I f o r F l y i n g L e a d s o r P l u g g a b l e C o n n e c t o r
Version Number
Figure 1.4.4: Typical MDMF, MDMP GUI
Your GUI may appear slightly different than the example shown above due to
different versions of MDrive Firmware. The Firmware is not upgradable but
the IMS Motor Interface will configure itself to your current Firmware
version. The Version Number will be displayed as indicated above.
The Factory Default settings are shown in the figure above and the following
figure. These settings may be changed to suit the user's application.
Connection Status & Port
29