Table of Contents
Advertisement
G5562A, G5563A Bravo Platform Safety and Installation Guide
To install the rear shield:
1
On the side of the Bravo Platform, press the power switch to the off (o) position (1),
and unplug the power cord (2). See the following figure.
Figure
Bravo Platform rear view
1
2
At the back of the Bravo Platform, remove the screw from the center lower edge of
the rear cover (3), as the preceding figure shows.
Save the screw for future use in case the shield is removed.
3
If applicable, route tubing or cables from any on-deck accessories through one of
the three deck-access windows in the rear shield.
4
While holding the shield in place to cover the rear deck opening, use a T10 driver to
install the screw (M3) at the top center of the shield into the screw hole in the Bravo
backplate.
2
3
00220
Bravo
Back
2 Installing the Bravo Platform
Installing the rear shield
47
Advertisement
Table of Contents
