Table of Contents
Advertisement
2 Installing the Bravo Platform
Installing the rear shield
Installing the rear shield
About this topic
Before you start
WAR NING
Installing the rear shield
46
Read this topic if you have a Bravo Platform that will be operated in an area where
access to the moving parts is possible through the rear opening in the backplate. This
topic describes how to install the rear shield to protect operators from moving-parts
hazards while the device is in operation.
The rear shield is not necessary if the back opening of the Bravo Platform is not
accessible to operators, for example, if the back opening is against a wall.
To prevent potential injury, turn off the Bravo Platform and disconnect the power cord
before you install or remove any accessory.
Make sure that you have the following:
•
Rear shield kit
•
Cross-tip screwdriver
•
2.5-mm and 3-mm hex wrenches
•
T10 and T20 Torx drivers
The following figure shows the installed rear shield, which is a clear panel that blocks
rear access to the deck through the opening in the Bravo backplate.
00220
Bravo
Back
G5562A, G5563A Bravo Platform Safety and Installation Guide
Advertisement
Table of Contents
