Table of Contents
Advertisement
2 Installing the Bravo Platform
Installing the Standard Light Curtain and shields
IMPORTANT
42
5
Slowly rotate the LED panels backwards again until the entire column of LEDs on
each panel turns solid green, indicating that the light beams are aligned.
The two indicator lights on the front of the Bravo backplate turn blue.
If any of the LEDs on the lightpost panel are partial green or blinking, the light beams are
not completely aligned. On the front of the Bravo backplate, the two indicator lights are
red if the light beams are not aligned.
Figure
Rotating the LED panels to align the light beams
6
Use a 2.5-mm hex wrench to tighten the two adjustment screws located near the
top and bottom of each lightpost's interior-facing side, as the following figure
shows (1).
G5562A, G5563A Bravo Platform Safety and Installation Guide
Bravo
Advertisement
Table of Contents
