Table of Contents
Advertisement
Installing the front shields
G5562A, G5563A Bravo Platform Safety and Installation Guide
Figure
Adjustment screws (
7
To verify the adjustment:
a
Press the Bravo power switch to the off (o) position, wait a minute, and then
press the power switch to the on (|) position.
b
Verify that the entire column of LEDs on each lightpost are solid green and not
blinking.
Before you start
Remove the protective backing from the shields.
If necessary, use a soft, lint-free cloth and isopropyl alcohol to clean the shields.
To install the front shields:
1
At the front of Bravo Platform, position the upper front shield so that the side with
the countersink screw holes is facing away from the device.
2
Secure the upper front shield to the top of the two lightposts using the four screws
provided.
3
Position the lower front shield so that the side with the countersink screw holes is
facing away from the device.
4
Secure the lower front shield to the two lightposts using the four screws provided.
After installation, the flat screw heads should be flush with the shield surface.
Installing the Standard Light Curtain and shields
1
) on the lightpost interior top and bottom
1
Bravo
1
2 Installing the Bravo Platform
43
Advertisement
Table of Contents
