Mechanical Installation - General Measure Checkweigher User Manual

Emergency
3
stop button
Electric
4
control box
5 Knob switch
Photoelectric
6
sensor
Photoelectric
7
reflectors
Check the
8 weight scale
table
9 Conveyor belt
Culling end
10
belt
Eliminate the
11
air blowout
12 Footing
13 Storage box
2.2

Mechanical installation

Place the checkweigher at the installation place and remove the sensor protection
device; Adjust the levelness of the checkweigher, and the inclination shall not exceed 0.5
degree; Fix the footing of the checkweigher, the stainless steel footing contacts the ground
smoothly, and lock the screws of the footing to ensure the stability of the checkweigher.
Adjust the distance between the check weighing platform and the front and rear end
conveying mechanism is 9 ~ 11mm, and the check weighing platform shall not be in
contact with other equipment. If the front and back end conveying mechanism is not equal
to the height, it is necessary to add the oblique conveying mechanism on one side, and add
the horizontal conveying mechanism connection on the side of the oblique mechanism (to
leave a gap) to check the weight scale platform, to ensure that the check weight scale
platform level and the height of the front and back end conveying mechanism.
Emergency stop
Control the weight checking process and connect
external devices
On/off check scale power
Judging object up and down weighing table
Use in conjunction with photoelectric sensors
The object to be measured is called the heavy
load platform
The delivery end of the scale table on the object
Disqualified products are culled at this location
Cull substandard products
Prevent the scale from sliding and shaking, and
adjust the level of the weighing table.
Store rejected nonconforming products
4
CW-100G (C01+MCGS)