Table of Contents
Advertisement
The electric control box can be arbitrarily installed on the left and right sides of the
checkweigher to facilitate the operation of the production process.
2.3
Electrical installation
The power supply is inserted into the three-hole socket with ground or connected to
the power supply equipment such as the electric gas cabinet according to the line mark.
Any wiring and disconnecting operation can only be carried out after power off. After
the operation is completed, check before power on.
2. The serial port is fixed to RS485 communication, where the 485(A) pair should be
connected to 485(A) or 485(+), and the 485(B) pair should be connected to 485(B) or
485(-).
3. The switching quantity input point is valid at low level (DC0V) and does not allow
access to high voltage or alternating current.
4. Switching quantity output point access relay coil for intermediate control, so the
other end of the relay can access DC or AC power supply switching quantity.
5
CW-100G (C01+MCGS)
Advertisement
Table of Contents
Need help?
Do you have a question about the Checkweigher and is the answer not in the manual?
Questions and answers