Working Parameters; Working Parameter Settings - General Measure Checkweigher User Manual

6. Working parameters

6.1

Working parameter Settings

Click "Set" to enter the interface of working parameters, and the user can decide
whether to open according to the production needs. If the corresponding alarm is generated
after opening, the weight checking scale will automatically alarm or alarm stop. It needs to
manually click "clear alarm" or input the signal of "clear alarm" to start the weight checking
again (after the alarm is generated and until the clear alarm is completed, The motor of the
check checkweigher runs but does not determine whether the object is on or off the
weighing platform, nor does it carry out weighing operation), and the alarm information is
stored in "Data" - "Alarm information".For specific operation methods, please refer to
"Operation Instructions of Button and Operation Frame" in section 3.3.2.
Analysis of working parameters:
Name
The alarm stops when
the queue is full
Figure 6-1 Working parameters screen example
Instructions
The default number of over/under error queue is 20, which
means that if the removal distance is long enough, that is, it
takes a long time for the products to be removed to arrive at
the removal institution, there can be more than 20 products in
the middle. If there are more than or equal to 20 over/under
33
CW-100G (C01+MCGS)