Kyocera ECOSYS MA6000ifx Operation Manual page 412

Setup and Registration (System Menu) > System Menu
Item
Toner Save Level (EcoPrint)
Copy
Printer
Print Density
Auto Color Correction
Correcting Black Lines
Auto Drum Refresh
Drum Refresh
Drum Refresh 2
*1 Displayed only when the optional FAX Kit is installed.
Select the default Toner Save Level (EcoPrint) .
Value:1 to 5
Raising the level reduces toner consumption, but image quality falls.
Select the default Toner Save Level (EcoPrint) .
Value: 1 to 5
Raising the level reduces toner consumption, but image quality falls.
Adjust print density. Adjustment can be made in 5 levels.
Value: 1 to 5
This setting allows you to adjust the detection level used by the machine to determine
whether the original is color or black and white in Auto Color Selection Mode. Setting a
lower value will result in more originals being identified as color, while a larger value will
tend to increase the number of originals being identified as black and white.
Value: 1 (Color), 2, 3, 4, 5 (B & W)
Correct fine lines (streaks caused by contamination), which may appear on the image,
when the document processor is used.
Value: Off, On
This specifies the Auto Drum Refresh execution time.
Value:
Off: Auto Drum Refresh not performed.
Short: Short Auto Drum Refresh execution time.
Standard: Standard Auto Drum Refresh execution time.
Long: Long Auto Drum Refresh execution time.
Remove image blur from the printout. It takes about 1 minute. The time required may
vary depending on the operating environment.
Drum Refresh (page 10-40)
NOTE
Drum Refresh cannot be performed while printing. Execute Drum Refresh after the
printing is done.
Remove white dots from the printout. It takes about 80 seconds. To use [Drum Refresh
2], load Ledger or A3 size paper into the Multipurpose tray.
When you run [Drum Refresh 2], the machine sometimes makes a vibrating sound for
about 80 seconds until drum refreshing is completed. The toner soiling on the ejected
paper is normal and does not indicate a fault.
Drum Refresh 2 (page 10-41)
NOTE
Drum Refresh 2 cannot be performed while printing. Execute Drum Refresh after the
printing is done.
8-63
Description