Loading By Ramp; Unloading By Ramp - Haulotte Compact 8 Operator's Manual

Compact 8 (C 2032E) - Compact 8W (C 2047E) - Compact 10 (C 2747E) - Compact 10N (C 2632E) -
Compact 10N-1 - Compact 12 (C 3347E) - Compact 14 (C 3947E)
D
- Operation instructions
5.6 - L
OADING BY RAMP
Ensure that :
• The loading ramp can support the machine weight.
• The loading ramp is correctly attached to transport vehicle.
• The loading ramp has sufficient grip surface.
• The transport vehicle must be parked on a level surface and must be secured to prevent rolling away
while machine is being loaded or unloaded.
To climb the slope, move progressively the drive joystick
If the slope is too steep, use a winch in addition to traction.
Do not place yourself below or too close to the machine during loading.
• Check the platform is completely empty. Do not use excessive downward force when securing platform/
basket.
• Drive the machine onto the truck bed.
• Secure the machine to the tie down points provided (Refer to
• The covers /swing out trays must be closed and locked in position. A wrong move can lead to machine
tipping over and may cause serious injuries and material damage.
The machine must be completely in the stowed configuration.
The extension deck must be retracted and locked during transport or towing.
5.7 - U
NLOADING BY RAMP
Before operating, check that the machine is in good condition.
If the machine has been damaged during transportation, contact the transporter in writing
1. Remove the tie downs.
2. Switch the machine on.
3. The ramp is in good condition and of sufficient capacity. The lifting equipment ie. slings, shackles,
hooks, lifting beam etc. are in good condition and of sufficient capacity.
4. Move progressively the drive joystick .
Upon starting a machine that has been secured and transported, the safety system may detect a false
overload preventing all movement from the platform control box.
To reinstate the system, lift the platform a few centimetres (inches) from the ground control box.
4001001030 E 06.20
(or ).
Section D 5.2 - Machine layout).
USA / GB
A
B
C
D
E
F
G
H
I
87