Slope Warning Device - Haulotte Compact 8 Operator's Manual

Compact 8 (C 2032E) - Compact 8W (C 2047E) - Compact 10 (C 2747E) - Compact 10N (C 2632E) -
Compact 10N-1 - Compact 12 (C 3347E) - Compact 14 (C 3947E)
C
- Pre-operation inspection
4.5 - S
LOPE WARNING DEVICE
The tilt sensor alerts the operator when it reaches the maximum permissible tilt. The tilt limita-
tion system activates if the heights defined in the "Transport position maximum height" table
are exceeded (
Drive and elevation controls are cut if this situation lasts longer than 1 or 2 s.
To restore the drive function, only movements allowing the machine to be stowed are permit-
ted :
• Platform lowered.
From each control box, a buzzer alerts the operator that the machine is not folded/stowed and
is positioned on a slope exceeding the slope allowed.
N.B.-:-T
When the unfolded machine is on a slope greater than the rated slope, out of the stowed
position, DRIVE and LIFT functions are disabled.
All functions speeds are reduced.
In this case, fully lower the platform and reposition the machine on level ground before raising
the platform again.
N.B.-:-D
IN ORDER TO CARRY OUT THIS OPERATION
Step
1 Pull the E-stop push-buttons on the platform and ground control boxes (144, 46).
2 Switch on the machine from the ground control box (92).
For COMPACT 8W - COMPACT 2047E - COMPACT 14 - COMPACT 3947E only :
3
Place the machine in maintenance configuration (
4 Locate the tilt sensor next to the ground control box.
Manually tilt and maintain the tilt sensor towards the front for a few seconds (
5
Layout).
6 The audible beep sounds.
7 For machines fitted with : The slope sensor prevents lifting and driving movements.
4001001030
Section C 4.6 - Travel speed limitation).
HE SLOPE SENSOR IS ONLY ACTIVE WHEN THE PLATFORM IS NOT IN THE STOWED POSITION
EPENDING ON YOUR MACHINE CONFIGURATION
To check the tilt sensor at ground control box
E 06.20
,
OUTSIDE ASSISTANCE MAY BE NECESSARY
.
Action
Section B 3.2 - Maintenance support).
Section B 3.1 -
USA / GB 69
A
B
C
.
D
E
F
G
H
I