Table of Contents
Advertisement
Accumulated Pulse Output Mode
ON
OFF
NOTE:
•
In case hysteresis is set at less than or equal to 2 digits, switch output may
chatter If Input pressure fluctuates near the set point.
•
When using window comparator mode, the difference between two set
points must be greater than the fixed hysteresis, otherwise will cause the
switch output to malfunction.
6.3 OUT2 Setting Selection
[F02] Setting corresponding sensor and operating mode of OUT2.
1. Press
or
[ovt2].
2. Check the [F-01] for the same follow setting.
NOTE:
The OUT2 Setting dose not have Accumulated Pulse Output Mode.
6.4 LCD Display Color Selection
[F-03] 4 LCD Display Color Modes of output value selection.
1. Press
or
tion Mode" to display [F-03] [CLor].
2. Press
button to switch to "Output Selec-
tion" (oVt1 - selected output).
3. Press
or
play for OUT 1 or OUT2.
4. Press
button to switch to "Display Color
Mode Selection".
5. Press
or
Color Mode".
[5oG] => ON = Green and OFF = Red
[5or] => ON = Red and OFF = Green
[grn] => ON = Green and OFF = Green
[red] => ON = Red and OFF = Red
EN-US · 30.30.01.02533 · 02 · 12/22
Flow Range
Pulse Output Rate
button at "Function Setting Mode" to display and start "OUT2 Setting" [F-02]
button at "Function Selec-
button to select color dis-
button to select "Display
6 Operation Instructions
Time
29 / 46
Advertisement
Table of Contents
