Reset Accumulated Flow Function; Peak Value Display; Bottom Value Display - Schmalz FS Series Assembly Instructions Manual

6.20 Reset Accumulated Flow Function
Accumulate flow value return to zero.
ü Sensor is at measurement mode (Accumulated flow value mode).
1. Press and
until display zero.
2. Release holding the buttons to return mea-
surement mode.
ð Accumulated value display zero.
6.21 Peak Value Display
The maximum pressure and instantaneous flow, from when the power was supplied to this moment, is
detected and updated.
ü Sensor is at measurement mode.
1. Press over 3 sec.
ð The maximum value will be displayed
flashing, and is held.
2. Press button return to the measurement
mode.
6.22 Bottom Value Display
The minimum pressure and instantaneous flow, from when the power was supplied to this moment, is de-
tected and updated.
ü Sensor is at measurement mode.
1. Press over 3 sec.
ð The minimum value will be displayed flash-
ing, and is held.
2. Press button return to the measurement
mode.
EN-US · 30.30.01.02533 · 02 · 12/22
simultaneously over 3 sec.
6 Operation Instructions
39 / 46