Analog Output Selection; Accumulated Value Hold Selection - Schmalz FS Series Assembly Instructions Manual

3. Press or
dard or normal condition.
Standard conditon (ANR) = [Anr]
Normal condition (NOR) = [nor]
NOTE:
1. Stardard condition (ANR): the display value
is calculated under 20°C, 1atm.
2. Normal condition (NOR): the display value is
calculated under 0°C, 1atm.
3. Flow rate in the specification is the value at
standard condition (ANR).
4. Press button to return to "Function Selec-
tion Mode".
6.9 Analog Output Selection
[F-08] Select the analog output signal is for flow sensor or pressure sensor.
1. Press or
tion Mode" to display [F-08] [ ang].
2. Press button to switch to "Sensor Selec-
tion".
3. Press or
of analog output (flow sensor or pressure sen-
sor).
NOTE:
1. This function is not available with Output
Specification -02 and -04.
4. Press button to return to "Function Selec-
tion Mode".
6.10 Accumulated Value Hold Selection
[F-09] The default setting is "OFF", the accumulated flow value is zeroed when the power supply is
turned off.
Select this function to keep accumulated flow value to be stored in permanent memory and reload the re-
cent saved accumulated value after power supply turns on.
1. Press or
tion Mode" to display [F-09] [ eepr].
2. Press button to switch to "Accumulated
Value Hold Selection".
EN-US · 30.30.01.02533 · 02 · 12/22
button to select the stan-
button at "Function Selec-
button to select the sensor
button at "Function Selec-
6 Operation Instructions
33 / 46