SMA SUNNY WEBBOX Bluetooth Wireless Technology Installation Manual page 34

Commissioning
5. Enter the Gateway IP address of your network into the "Gateway IP" field. Usually, the IP
address of the router should be entered here.
6. In the "IP Address" field, enter the static IP address under which the Sunny WebBox is to be
reachable in the local network (see section 13.7 "Allocating an IP Address in a Local Network"
(page 64)).
7. In the "Subnet mask" field, enter the subnet mask of your network. Normally, you can find this
information in the router manual.
8. Select [Save].
☑ The Sunny WebBox saves the network settings. The saving procedure can take up to
30 seconds. Do not disconnect the Sunny WebBox from the power supply during the saving.
The saving procedure is complete when you are directed to the new IP address or the Sunny
WebBox is no longer available via the web browser.
Resetting the computer to the network settings.
Reset your computer to the original network settings, in order that you can reach it via the
local network when required (see section 6.4 "Configuring Network Settings on the
Computer" (page 28)).
9. When the saving procedure is completed, remove the plug-in power supply of the Sunny
WebBox from the socket outlet.
10. Remove the network cable (blue).
☑ The local network settings are applied to the Sunny WebBox.
You may now connect the Sunny WebBox to the local network (see section 35).
34 SWebBox20-eng-IUS111411
SMA America, LLC
Installation Guide