Table of Contents
Advertisement
Commissioning
6.2 Configuring Bluetooth Settings for the Sunny WebBox
The Bluetooth settings of the Sunny WebBox are to be made using the rotary switch of the Bluetooth
module using a screwdriver (
NOTICE
Changing the NetID during operation of the Sunny WebBox
If the NetID of the Sunny WebBox is changed during operation, the Sunny WebBox gets
restarted. Then, all devices with the same NetID are searched for and displayed in the plant
tree.
At the present time, NetID 1 is not supported by the Sunny WebBox.
A direct connection to an individual SMA Bluetooth device via NetID 1 is currently only
possible with the Sunny Explorer software or the Sunny Beam with Bluetooth.
Change the NetID of the Sunny WebBox to the NetID of your PV plant (NetID 2 to NetID F).
1. Turn the "MODE" rotary switch to position "0". The rotary switch must always be set to position
"0" (status on delivery). Other positions are not permitted and are intended for SMA Service
only.
2. Turn the arrow of the "NetID" rotary switch to the
NetID of the PV plant. For a layout of the switch
positions, see the table.
NetID
0
1 (Status upon delivery)
2-F
☑ The Sunny WebBox is prepared for Bluetooth communication.
You can now directly connect the Sunny WebBox to the computer with which you would like to
configure the Sunny WebBox (see page 27).
26
SWebBox20-eng-IUS111411
3
⁄
in. (2.5 mm)).
32
Function
Bluetooth is switched off.
No function
Bluetooth is switched on.
The Sunny WebBox can network with all SMA Bluetooth
products with the same NetID. Connecting to the Sunny Beam
with Bluetooth or Sunny Explorer is not possible.
SMA America, LLC
Installation Guide
Advertisement
Table of Contents
