Knx Convertor For Indoor Unit - Fujitsu Airstage J-IVS AJ 040LCLDH Series Design & Technical Manual

2-23. KNX convertor for Indoor unit

¢ Switch location
Set Programming (Prog) button on the KNX convertor PCB.
¢ Programming (Prog) button setting
• Prog button: Mode setting when communicating with the ETS
Push to switch between Runtime mode and Programming mode.
PROG LED
¢ Configuration and setting up
This is a fully compatible KNX device which must be configured and setup using standard KNX
tool ETS.
For how to configure the settings from the ETS, refer to the Interface Specification.
ETS database for this device can be downloaded from:
https://fujitsu-general.com/global/support/downloads/vrf/index.html
2-23. KNX convertor for Indoor unit
LED5 LED6
<GRN> <ORG>
ON
OFF
Prog button
PROG LED
<RED>
LED7
<RED>
Mode setting
Programming mode
Runtime mode
- (07-137) -
Factory setting
♦
2. Function settings