Fujitsu Airstage J-IVS AJ 040LCLDH Series Design & Technical Manual page 770

Hide thumbs Also See for Airstage J-IVS AJ 040LCLDH Series:

Table of Contents

 Completion of address setting mode

• The position of the MANUAL AUTO button varies depending on the model. For the actual position

of the button on each unit, refer to the operation manual.

• If the MANUAL AUTO button is pressed continuously for 10 seconds or more, the error will be dis-

played. In this case, release the button or turn off the power.

Press and hold the MANUAL AUTO button for 3 seconds. The brightness of each LED lamp is

darkening though the content of the display does not change.

Press the RESET button.

For the custom code setting of b, c, or d, perform the setting after pressing the RESET button.

• After completing the procedure above, no address setting signal is received. If the address

setting signal is sent, 5 short beeps will be emitted indicating an error.

• When returning the address setting mode again, press the MANUAL AUTO button for 3 sec-

1-4. Address setting by remote controller

IR receiver unit

3 short beeps

1. System settings

Chapters

Table of Contents