Fujitsu Airstage J-IVS AJ 040LCLDH Series Design & Technical Manual page 911

– Electricity apportionment for DX kit
[When electricity meter not connected]
The following units can be linked to the DX-Kit, by using external output terminals.
[A]: External fan
[B]: Units linked to run/stop state external output
At electricity apportionment, the DX-Kit itself and units [A] and [B] mentioned above can be han-
dled. Set the electricity value at ON beforehand for the units [A] and [B] from the "Parameter
Setting" screen. The input value is included in the calculation as a constant value when the ex-
ternal output terminal is ON.
[When electricity meter is connected]
At electricity apportionment, the DX-Kit itself and units [A] and [B] mentioned above can be han-
dled the same as when an electricity meter is not connected. Set the electricity value at ON be-
forehand for the units [A] and [B] from the "Parameter Setting" screen and install the electricity
meter so that the units [A] and [B] are included. The input value in the calculation as a constant
value when the external output value is ON is included.
If there is a unit related to the DX-Kit other than [A] and [B], if the DX-Kit is connected as an
independent electricity meter system and installed so that other units are included, it may be in-
cluded in electricity charge apportionment. (All the value of that electricity meter is charged to
the DX-Kit.
Whm
2-30. Electricity charge apportionment setting (System controller, Touch panel
controller)
Whm
DX kit
[B] External fan
[A] Run/stop state
External output linked units
Whm
DX kit
[B] External fan
[A] Run/stop state
External output
Whm
linked units
Whm
DX kit
[B] External fan
[A] Run/stop state
External output linked units
DDC/Damper/Heater, etc.
- (07-165) -
DX kit
[B] External fan
[A] Run/stop state
External output linked units
The electricity meter is installed so that the
units [A] and [B] are included.
The electricity meter is installed
independently from the units [A] and [B].
The electricity meter is installed so that [A],
[B], and other units are included.
2. Function settings