Table of Contents
Advertisement
3
STEVAL-BCN002V1D host board for programming and debugging
The STEVAL-BCN002V1D is used to Flash and debug the STEVAL-BCN002V1 BlueTile sensor node.
During Flashing and debugging, remove the battery as the
host board, which receives its supply voltage through its USB connector or on the USB connector of the ST-LINK
V3 Stamp if you are using it.
The BOOT and RESET pin of the
or by the ST-LINK V3 Stamp if used, or by the user (user button and connector CN5).
UM2501 - Rev 3
STEVAL-BCN002V1D host board for programming and debugging
Figure 5.
STEVAL-BCN002V1D top and bottom
BlueNRG-2
BlueNRG-2
on the BlueTile are controlled by the STM32L1 on the host board,
device on the BlueTile is powered by the
UM2501
page 20/44
Advertisement
Table of Contents
