Table of Contents
Advertisement
iRIS4 - Addressable Fire Alarm Panel – Installation Manual
4.6. LAN connection
The realization of LAN network is possible only for Repeaters TFT model and iRIS4 and iRIS8 series addressable fire
alarm panels (up to 64). The LAN connection can be direct panel-to-panel or by means of a HUB via TCP/IP protocol.
To operate in LAN network with other iRIS4, iRIS8 and Repeater TFT panels the installer must set for all panels "LAN"
type of the communication protocol.
5. SUPPLEMENTARY INFORMATION
5.1. Periphery Devices
All "functional modules" connected to the control panel configuration are defined as Periphery Devices, and have
special programming and settings.
Attention: The Interface module and Main control module PCB are not periphery devices!
Up to 6 periphery devices can be added to the system configuration of iRIS4 panel.
Periphery Device
PSU – Main power supply
OUT – Outputs module
LOOP – Loop controller (expander)
The periphery devices have factory set address numbers that cannot be changed. The loop controllers always take
addresses from 3 to 6.
The following drawing of the hardware configuration of iRIS4 panel models and table represent the fixed factory
addresses of the periphery devices, which must be assumed during the initial power up and programming of the whole
system.
Figure 33
iRIS4
1
1
4
System
Name
PSU
OUT
LOOP
LOOP
LOOP
LOOP
The free addresses for periphery devices are
Figure 34
28
Periphery
Factory
Device
Address
Power Supply
Output module
LOOP 1
LOOP 2
LOOP 3
LOOP 4
presented as EMPTY.
1
2
3
4
5
6
Advertisement
Table of Contents
