Mile Marker PE Series Installation And Operator's Manual page 23

MX Series Winch Systems
Winch Operation
1. Disengage the clutch by moving the Cam Ring to
OUT Position (or Freespool mode) (Fig. 5-2).
2. Reel-out the cable and connect to the desired an-
chor point (self recovery) or vehicle being recovered.
3. Fully Engage the clutch by moving the Cam Ring
to "IN"Position (Fig. 5-2).
4. Lift the protective boot covering the hand control
plug-in. Insert the hand control plug. The remote
control BLUE lights should TURN ON. Now you are
ready to winch! (Fig. 5-3).
5. Start winching IN (GREEN lights on both, Remote
Control and Control Box, should TURN ON, Figs. 5-4
& 5-5) slowly to remove the slack on the cable and
5-4: Hand Control Function
ensuring that the cable is winding onto the drum
properly (with out any overlapping or gaps). Never
disengage the clutch while the cable is under load!
6. When finished winching, slowly let off the load by
winching OUT (RED lights on both, Remote Control
and Control Box should TURN ON, Fig. 5-4), unhook
the cable and re-wind the cable onto the drum.
7. Unplug the hand control and push the protective
boot cover back on to the Plug-in (Fig. 5-6).
5-5: Hand Control Operation
5-2: Clutch Engagement
5-6: Hand Control Removal: Push Button to Release
5-3: Hand Control Connection to Box
23