Sx/Si/Sec Series - Mile Marker PE Series Installation And Operator's Manual

Control Box Installation Cont'd
SX/SEC Series Winches Cont'd
4. Further secure the bracket to the motor using the
provided tie-wrap (Fig. 2-6).
5. Slips the boots onto pertinent cables and make
electrical connection in accordance with the sche-
matic below. Slide the boots onto all the electrical
connections made (figs. 2-7 through 2-12).
6. The small black wire MUST attach to the battery
ground terminal (fig. 2-13).
7. Refer to the Winch Operation section and test the
winch for proper functioning.
2-3: Hardware Placement on Control Box: (A) SX Models, and
(B) SEC Models
2-4: Mounting Point on Die Cast for Control Box SX/SEC Series
A
B
12
2-5: Control Box Aligned with Mounting Points: SX/SEC Series
2-6: Secure Box Assembly with Tie-Wrap
CAUTION: Do Not Connect Cables to Bat-
tery until unit is completely wired to con-
trol box and installed on vehicle. Reserve
for last step of installation.
2-7: Complete Wiring Schematic: SX/SEC Series