Mile Marker PE Series Installation And Operator's Manual page 21

MX Series Winch Systems
Low Voltage/Low System Charge Warning
1. If the vehicles charging system (measured at the
motor control pack) drops below a safe voltage the
LED lights will flash. This is to warn you that your
charging system is dangerously low and you may not
be able to safely use your winch much longer.
2. If the vehicle's charging system (measured at the
motor control pack) continues to drops below a safe
voltage then LED lights will flash and the winch's
on-board computer will shut the winch off. This is to
protect your winch and your vehicle.
3. After a short time and if the vehicles charging sys-
tem is at a safe voltage then the winch controller on
board computer will let you use the winch again.
4. You cannot OVERRIDE this Low-Voltage Feature!
Over Temperature Warning
1. The winch's on-board computer can detect if the
winch temperature has gotten too hot. When your
winch gets too hot then the LED lights will flash and
the on-board computer will shut the winch motor
off.
2. If you press the IN and OUT buttons and the same
time on the wired remote control than you can
OVERRIDE this safety feature and continue to use
the winch.
NOTE: OVERRIDING the safety feature will void your
warranty and is UNSAFE! See the over ride feature
for more details.
Safety Features
Line OUT Time Warning
1. If the winch's on-board computer detects that the
OUT button has been pressed for about 10 seconds
the winch motor will turn off.
2. After about 5 seconds the on-board computer will
allow you to use the OUT button again to spool the
winch cable out.
3. If you press the IN and OUT buttons at the same
time on the wired remote control than you can OVER-
RIDE this safety feature.
NOTE: OVERRIDING the safety feature will void your
warranty and is UNSAFE! See the over ride feature
for more details.
OVERRIDE
1. If the winch motor control on-board computer de-
tects a problem it will shut down the winch motor
and flash the LED lights. These safety features are
designed to ensure your safe operation and protect
the product from misuse, allowing the winch to aid
you in recovery time and time again.
2. The on-board computer will record in the flash
memory what problem happened.
3. By pressing the IN and OUT buttons on the wired
remote at the same time you can go into a manual
OVERRIDE, and regain normal winch operation.
4. If you OVERRIDE any of the on-board computer
safety features you WILL VOID YOUR WARRANTY!
21
5-1: Safety Feature Override