Mile Marker PE Series Installation And Operator's Manual page 10

Control Box Installation Cont'd
MX/PE/E Series Winches Cont'd
5. Slip the boots onto pertinent cables and make
electrical connection in accordance with the sche-
matic (Figs. 1-8 & 1-9). Slide the boots onto all the
electrical connections made.
6. The small black wire MUST attach to the battery
ground terminal.
7. Refer to the Winch Operation section and test the
winch for proper functioning. If the winch drum is
rotating in the opposite direction when pressed IN,
switch the cables going into the motor and re-test.
1-4: Mounting Point on Tie Bar for Control Box MX/PE/E Series
1-5: Loosen Only ONE tiebar at a time
1-6: Secure at Tie Bars with Allen Wrench
1-7: Secure Box Assembly with Tie-Wrap
1-8: Complete Wiring Schematic: MX/PE/E Series
10
CAUTION: Do Not Connect Cables to Bat-
tery until unit is completely wired to con-
trol box and installed on vehicle. Reserve
for last step of installation.
1-9: Attach Boots to Cable Ends