Mile Marker PE Series Installation And Operator's Manual page 11

Control Box Installation Cont'd
MX/PE/E Series Winches Cont'd
1-10: Stud Diagram: MX/PE/E Series
1-10: Yellow and Blue Cables: Winch Motor and then to Box
1-11: Complete Stud Diagram: MX/PE/E Series
1-12: Complete Control Box: MX/PE/E Series
SX/SEC Series Box Installation
You will need a 14mm, 13mm, and a 10mm wrench
and metric Allen wrenches. Also you will need gen-
eral hand tools for mounting the winch.
1. Unpack the control box and its bracket (fig. 2-1).
2. Align the studs/holes on the bottom of the control
box with the holes on the bracket and fasten the con-
trol box to the bracket using the provided washers
(#6 Metric), spring washers (# 6 metric) and Bolts
(M6)or Nuts (M6)
3. Mount the motor control box to the motor die
casting (figs. 2-4 & 2-5).
A
B
2-1: Hardware, Mount, and Control Box: (A) SX and (B) SEC
A
2-2: Mount Place-
ment on Control
Box: (A) SX
Models, and (B)
SEC Models B
11